en
30
Appliance is not cooling,
temperature display and
lighting are lit up.
Showroom mode is switched
on.
Press and hold °C button and @ setting button
for 5 seconds until a confirmation tone sounds.
Another confirmation tone sounds when the
buttons are released.
After a short time, check whether your
appliance is cooling.
The side panels of the
appliance are warm.
The side panels contain
pipes which heat up during
the cooling process.
That is normal behaviour for the appliance and
not a fault.
Furniture touching the appliance will not be
damaged by the heat.
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
The evaporator (refrigeration
generator) in the NoFrost
system is covered in thick ice
and can no longer be
defrosted fully automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well and
store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan, at the rear of
the appliance.
To prevent the evaporation pan from
overflowing in this case, mop up
the condensation with a sponge.
The evaporator is defrosted when the
condensation stops running into the
evaporation pan. Clean the inside. Switch the
appliance back on again.
Automatic super freezing
does not switch on.
The appliance decides independently whether
automatic super freezing is required and
automatically switches it on or off.
The following settings are
switched off:
■ Audible signals
■ Interior lighting
■ Messages on the display
panel
■ Automatic super freezing
The background illumination
of the display panel is
reduced.
Buttons are locked.
Sabbath mode is switched
on.
Press the super button for 15 seconds.
To Next Page
Loading...
