Installation instructions en
19
Installing the appliance bracket
1.
Screw on the appliance bracket for the extractor
hood hand-tight.
2.
Use a spirit level to align the appliance bracket hori-
zontally and screw it firmly in place.
3.
Screw the enclosed sleeves fully into the upper ap-
pliance bracket.
Installing the appliance
1.
Place the mains plug on top of the appliance.
2.
Remove the grease filters.
3.
Hook the appliance into the appliance bracket from
above so that it clicks firmly into place.
4.
To align the appliance, if necessary, adjust the
height of the appliance from above using a screw-
driver.
5.
Secure the appliance from above using 2 nuts.
To Next Page
Loading...
