ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
en Connecting to a hob
10
Saturation display
If the metal grease filters or the activated charcoal filter
are/is saturated, the corresponding symbols flashes
after the appliance is switched off:
■ Metal grease filters: !
■ Activated charcoal filter: "
■ Metal grease filters and activated charcoal filter: !
and "
If you have not yet done so, the metal grease filters
should now be cleaned or the activated charcoal filter
replaced. ~ "Cleaning and maintenance" on page 13
Note: The saturation indicator does not apply for non-
renewable activated charcoal filters that are inserted
downstream of the metal grease filter. These activated
charcoal filters must be replaced twice a year.
The saturation indicators can be reset while they are
flashing. To do this, touch the # and A symbols at the
same time.
Switching over the display for air circulation mode
For air recirculation mode, the electronic controller must
be switched over accordingly:
■ The extractor hood must be connected and switched
off.
■ Touch and hold the # and @ symbols at the same
time until "2" lights up for air recirculation mode
(filters that cannot be regenerated).
■ Touch and hold the # and @ symbols again at the
same time until "3" lights up for air recirculation
mode (filters that can be regenerated).
■ Touch and hold the # and @ symbols again at the
same time until the electronic controller has
switched back to air extraction mode (indicator 1 ).
Audible signal
Switching on
With the fan switched off, touch and hold the # and &
symbols at the same time for approximately 3 seconds.
A signal will sound as an acknowledgement.
When the signal tone is activated, ‚ will be lit.
Switching off
With the fan switched off, touch and hold the # and &
symbols at the same time for approximately 3 seconds.
A signal will sound as an acknowledgement.
When the signal tone is deactivated, ‹ will be lit.
eConnecting to a hob
Connect i ng to a hob
You can connect this appliance to a hob (if the hob
supports connection to the appliance) and then control
the functions of the hood via your hob.
Appliances can be connected to each other in different
ways:
Home Connect
Two appliances can be connected using the Home
Connect app provided that both of them are Home
Connect compatible.
Refer to the Home Connect documents supplied for
more information.
Connecting appliances directly
If the appliance is connected directly to a hob, it cannot
be connected to your home network as well. The
appliance will function as an extractor hood that is not
connected to the network and you can continue to
operate it via the control panel.
To Next Page
Loading...
Need help?
General
