6
Operation
Note: Switch on the extractor hood when you start cooking and
switch it off again several minutes after you have finished
cooking. This is the most effective way of removing the kitchen
fumes.
Control panel
Preparing the appliance for operation
1. Press the top right of the filter cover.
2. Open the filter cover until you begin to feel resistance.
It will open by about 4 cm.
Setting the fan
Note: Always adjust the fan strength to meet current conditions.
If there is a large build-up of steam or fumes, select a high fan
setting.
Switching on
1. Press the # button.
The fan starts at fan setting
ƒ.
2. Press the N or M button to set a different fan level.
Switching off
Press the
# button.
Intensive setting
You can use the intensive setting if there is a large build-up of
odours and fumes/vapours.
Switching on
1. Press and hold the N button until the intensive mode‚2
appears in the display panel.
The intensive mode
‚2 is activated.
2. Press and hold the N button until the intensive modeƒ2
appears in the display panel.
The intensive mode
ƒ2 is activated.
Note: The run time of the intensive mode is
approx. six minutes. Once this time has elapsed, the appliance
switches back to a lower fan setting.
Switching off
Press the
M button until the required fan setting is reached.
The intensive mode ends.
Boost function
The boost function is a short-term maximum power setting
which can be activated in any fan setting.
Press the
& button.
After approx. 20 seconds, the fan switches back to the
previously set fan setting.
Fan run-on
With fan run-on, the appliance switches off automatically after
10 minutes.
Switching on
Press the
x button.
Note: The fan run-on can be activated for all fan levels.
Switching off
Press the
x button.
Lighting
The lighting can be switched on and off independently of the
ventilation system.
Switching on or off
Press the
= button.
Setting the brightness
Press and hold the
= button until the required brightness is
reached.
LQW
Explanation
#
Fan on/off
=
Light on/off/dimming
- Reduce the fan settings/fan run-on time
+ Increase the fan settings/intensive mode 1, 2
&
Boost function (short-term maximum power)
x
Fan run-on
To Next Page
Loading...
Need help?
General
