6/22
Building Technologies CC1N7435en
HVAC Products 11.01.2007
Ordering
Burner control, without plug-in base refer to «Type summary»
Connection accessories for small burner controls refer to Data Sheet N7201
- Plug-in base AGK11...
- Cable holders AGK65..., AGK66, AGK67...
- Cable strain relief elements for AGK67...
Connection accessories for small burner controls refer to Data Sheet N7203
- Plug-in base AGK13...
- Plug-in housing AGK56
- Accessories AGK68
Flame detectors
- Ionization probe supplied by thirds
- UV- flame detectors QRA2... / QRA10... refer to Data Sheet N7712
- Blue-flame detectors QRC1... refer to Data Sheet N7716
RC unit ARC 4 668 9066 0
For the supervision of ionization currents in networks with nonearthed neutral conductor
PTC resistor (AC 230 V) AGK25
To burden terminal 3 (mandatory when using burners with no fan
motor connected to terminal 3)
Auxiliary unit for UV supervision
- Cable length 500 mm AGQ1.1A27
- Cable length 300 mm AGQ1.2A27
- Can be fitted under the plug-in base (refer to «Dimensions»)
Pedestal (empty housing) AGK21
- For increasing the height of the LGB... to that of the LFM... or LFI7...
Service adapter KF8872
- For checking the functioning of the burner controls on the burner plant
- Functional test with signal lamps
- Detector resistance measurement with a jack of 4 mm diameter
Adapters / replacement types
No rewiring required
KF8852
LFI7...
LGB21... with adapter
KF8880
LFM1... ¹)
LFM1...-F ¹)
KF8853-K
LFI7...
LGB22... with adapter
KF8880
LFM1... ¹)
LGB41... with adapter KF8862
LFM1... ¹)
¹) Designed only for ionization
To Next Page
Loading...
