Siemens LI97SA561S - Cleaning and Servicing

Cleaning and servicing en
7
7.7 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
▶
Press or slide in the filter pull-out.
a The appliance switches off automatically after ap-
prox. 10 minutes.
7.8 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
▶
Press ⁠.
7.9 Setting the brightness
▶
Press and hold until the required brightness is
reached.
7.10 Switching on the audible signal
Requirement:The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. threeseconds until a signal sounds.
7.11 Switching off the audible signal
Requirement:The appliance is switched off.
▶
Press and hold and at the same time for ap-
prox. threeseconds until a signal sounds.
7.12 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.13 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off, ap-
pears in the display for the grease filter.
¡ After the appliance has been switched off, ap-
pears in the display for the odour filter.
¡ A signal sounds repeatedly.
▶
Press ⁠.
a The saturation indicator is reset.
7.14 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement:The appliance is switched off.
1.
To set circulating-air mode for the standard odour
filter, press and hold and until ⁠ appears in
the display.
2.
To set circulating-air mode for the CleanAir standard
odour filter or the CleanAir Plus odour filter, press
and hold and repeatedly until ⁠ appears in
the display.
3.
To set the exhaust-air mode, press and hold and
repeatedly until appears in the display.
8 Cleaning and servicing
To keep your appliance working efficiently for a long
time, it is important to clean and maintain it carefully.
8.1 Cleaning products
You can obtain suitable cleaning products from after-
sales service or the online shop.
WARNING‒Risk of electric shock!
An ingress of moisture can cause an electric shock.
▶ Before cleaning, pull out the mains plug or switch
off the fuse in the fuse box.
▶ Do not use steam- or high-pressure cleaners to
clean the appliance.
WARNING‒Risk of burns!
The appliance becomes hot during operation.
▶ Allow the appliance to cool down before cleaning.
ATTENTION!
Unsuitable cleaning products may damage the sur-
faces of the appliance.
▶ Do not use harsh or abrasive detergents.
▶ Do not use cleaning products with a high alcohol
content.
▶ Do not use hard scouring pads or cleaning
sponges.
▶ Only use glass cleaners, glass scrapers or stainless
steel care products if recommended in the cleaning
instructions for the relevant part.
▶ Wash sponge cloths thoroughly before use.