EPAC300-M50 SERIES USER’S MANUAL
AUGUST 2005 PAGE 35 OF 46
A CP 11945 P001
Suffix: Different parts made
from the same drawing
Part Number
Category: AZ = Top Assembly
AD = Subassembly
BW = Wire Assembly
CP = Circuit Board
Prefix: A = Assembled Part
F = Fabricated Part
P = Purchased Part
S = Schematic Diagram
In the above example, the part identified as 11945 has the following:
FCP11945 Circuit Board Fabrication Drawing
FCP11945P001 Circuit Board Fabricated Part Number
ACP11945 Circuit Board Assembly Drawing
ACP11945P001 Circuit Board Assembled Part Number
ACP11945P001 Circuit Board Assembly Parts List
AAD11945 Subassembly Drawing
AAD11945P001 Subassembly Part Number
AAD11945P001 Subassembly Parts List
In this example, the bare printed circuit board FCP11945P001 is fabricated by
following the FCP11945 drawing. If another part could be fabricated using the
FCP11945 drawing, its part number would be FCP11945P002. The FCP11945P001
and the other parts called out on the ACP11945P001 Parts List are assembled to
become the Circuit Board Assembly ACP11945P001 by following the ACP11945
drawing.
If another part could be assembled using the ACP11945 drawing, its part number
would be ACP11945P002, and its Parts List would be ACP11945P002. The
Schematic Diagram for ACP11945P001 is the SCP11945 drawing. The
ACP11945P001 and the mounting hardware called out on the AAD11945P001 Parts
List are assembled to become the Subassembly AAD11945P001 by following the
AAD11945 drawing. If another part could be assembled using the AAD11945
drawing, its part number would be AAD11945P002, and its Parts List would be
AAD11945P002.
The subassembly AAD11945P001, along with the other major subassemblies is
then assembled into the AAZ11920P001 Top Level Assembly using the AAZ11920
drawing and Parts List.
To Next Page
Loading...
