Siemens M65 - Page 14

SIEMENS PTE LTD
M65 Level 2 Service Manual
Copyright © Siemens Pte Ltd. Siemens Technical Support Centre
All Rights Reserved May 2004
ICM MP CCQ SLI RHQ Page 14 of 37 Company Confidential
7 Disassembly of M65
Note: ESD concept; the internal circuits will be more susceptible to ESD because of
the use of exchangeable housing. The construction of the internal block must be/is
designed, in the best possible way, to protect the circuit against sparks.
The keypad must be completely closed to prevent any occurrence of an ESD
disruptive discharge.
The SIM contacts may be open, thus reachable for ESD contact discharge. This
could lead to damage or destruction of the E-Gold pins.
It is a requirement for the service personnel to observe ESD protection rules while
performing servicing the M65.
Step 1
Front view of the M65
Step 2
Back View of the M65
Step 3
Unlatch the Bayonet Latch to remove the Metal Clip.
Step 4
Remove the RF/Camera Plug, Rubber Ring, Battery
Cover and I/O Sealing Plug from the Lower Case.