EasyManuals Logo

Siemens MCP 398C Diagnostic Manual

Siemens MCP 398C
1054 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
NCK alarms
03/2009 Overview of Alarms
2-27
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Error parameters:
- 1 : NC Ready missing
- 16: At least one other channel is active
- 35: AXCT axis is active following axis/spindle
- 36: AXCT axis is active leading axis
- 39: Axis/spindle disable active
- 40: Overlaid motion active for AXCT axis
- 41: Axis exchange active for AXCT axis
- 42: Interpolator active for one axis container axis
- 46: Rotating spindle with different Ipo cycle of NCUs
- 47: New-Config active
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: The program must be canceled with Reset and the zero offset deselected before activating the axis
container switch.
Program Con-
tinuation:
Clear alarm with the RESET key. Restart part program
4020 Identifier %1 used several times in machine data %2
Parameters: %1 = String: Name of identifier
%2 = String: MD identifier
Definitions: When determining a name in the NCK tables (arrays) for: machine axes, Euler angles, direction vec-
tors, normal vectors, interpolation parameters and intermediate point coordinates, an identifier has
been used that already exists in the control.
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Select for the identifier to be entered a
character string that is not yet used in the system (max. 32 characters).
Program Con-
tinuation:
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
4021 [Channel %1: ] Identifier %2 used several times in machine data %3
Parameters: %1 = Channel number
%2 = String: Name of identifier
%3 = String: MD identifier
Definitions: To determine the name in the channel-specific tables for geometry axes and channel axes an identifier
already existing in the control has been used.
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Select for the identifier to be entered a
character string that is not yet used in the system (max. 32 characters).
Program Con-
tinuation:
Switch control OFF - ON.
4022 [Channel %1: ] Axis %2: axis container %3 switch not allowed: ext. work
offset active
Parameters: %1 = Channel
%2 = Axis/spindle
%3 = Axis container number

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals