Siemens Climatix Series User Manual

Control Equipment
Siemens Climatix
Basis Document Climatix Control System

Siemens Climatix Series Specifications

General

Application	HVAC control
Communication Protocols	BACnet, Modbus, KNX
Inputs	Analog and digital inputs
Outputs	Analog and digital outputs
User Interface	web interface
Power Supply	24 V AC
Protection Class	IP20
Mounting	DIN rail mounting

Summary

Siemens Climatix

Basis Document Climatix Control System

Provides the foundational information for the Climatix Control System.

2.3 Safety

4 Hardware overview

4.1 Basic controller (POL638x)

Details the specifications and connections of the basic controller.

5 Functions

5.1 Global functions

Details general functions applicable to the entire system.

5.2 Operating mode

5.2.2 Prioritize various operating modes and switch-on sequences

5.3 Damper control

5.3.1 General

Explains damper control setup and functions.

5.4 Fan control

5.4.1 Configuration

Details the configuration settings for fan control modes.

5.5 Temperature control

5.5.1 General

Provides an overview of temperature control functions.

5.6 Heat recovery damper

5.6.1 General

Details the setup and operation of heat recovery dampers.

5.8 Heating / Heating 2

5.8.1 General

Provides an overview of heating and heating 2 functions.

5.9 Electrical heating / Electrical heating 2

5.9.1 General

Details electrical heating and electrical heating 2 setup.

5.10 Cooling / Cooling 2

5.11 Humidity control

5.13 Auxiliary functions

5.14 Alarm handling (Alarm outputs)

6 Detail pages: Inputs and outputs

7 Detail pages: Controller

7.1 Loop controller

Details the parameterization of PID loop controllers.

8 Detail pages: Time switch program

9 Communication

9.5 Room units

9.5.1 Commission room unit

Details the process for commissioning room units.

9.5.2 Prioritize various operating modes and switch-on sequences

11 Save / restore parameters

12 Onboard WEB functionalities

13 System settings

13.1 Password settings

Details the system's password protection levels.

13.6 HMI (operating unit)

13.7 Diagnostics

14 SD card and modem

14.1 SD card functions (Update application)

Details SD card functions for application updates.

15 Configuration

15.1 Configuration 1

15.2 Configuration 2

15.3 Configuration I/Os

15.3.1 Start page

Details the start page for I/O configuration.

17 HMI

17.6 Configuration 1

17.9 Check config I/Os

18 Time scheduler

18.1 Week schedulers

Details the setup and operation of week schedulers.

19 Alarming

20.4 Parameter list room unit