Need help?Do you have a question about the Siemens LOGO! CSM 12/24 and is the answer not in the manual?
General| Product type designation | LOGO! CSM 12/24 |
|---|---|
| Supply voltage | 12/24 V DC |
| Analog Inputs | 0 |
| Analog Outputs | 0 |
| Programming Software | LOGO! Soft Comfort |
| Switching technology | Relay |
| Protection class IP | IP20 |
| Mounting type | DIN rail |
| Data Memory | 1000 bytes |
| Clock Backup | Yes |
| Communication | Ethernet |
| Communication Interfaces | Ethernet |
| Transfer rate | 10/100 Mbps |
| Protocols | SNMP |
| Operating temperature | 0 to 55 °C |
Details the specific hardware and software components required for the house control automation solution.
Lists the specific hardware and software components with article numbers and relevant notes for implementation.
Explains how wind and light sensors are processed for automatic blinds control based on environmental conditions.
Guides on configuring network mode, adding devices, and creating projects in LOGO! Soft Comfort network view.
Describes how to connect function blocks and exchange data between LOGO! devices using drag & drop.
Instructions for hardware installation, network setup, IP addressing, and KTP400/LOGO! 8 configuration.
Step-by-step guide to assign IP addresses and configure the master mode on LOGO! 8 controllers.
Guides on commissioning the system and performing basic settings on the KTP400 HMI panel.
Instructions on how to load WinCC projects into the KTP400 and KTP700 panels.
Details project tree navigation, IP address entry, and cyclic operation settings for HMI configuration.
Steps for downloading the project to the KTP400, including network interface selection and confirmation.
To Next Page