To Next PageTo Next Page
Need help?Do you have a question about the Siemens LGK16.322A27 and is the answer not in the manual?
General| Type | LGK16.322A27 |
|---|---|
| Ignition transformer control | Yes |
| Application | Burner control |
| Gas type | Natural gas |
| Voltage | 220-240 V AC |
| Frequency | 50-60 Hz |
| Flame supervision | Ionization or UV |
| Safety time | 3 seconds |
| Approval | EN 298 |
Summarizes main capabilities like fuel type, capacity, operation modes, and supervision.
Essential warnings for handling, installation, and operation to prevent hazards.
Lists LOK16 model types, preferred uses, and detailed switching time parameters for oil burners with photocell detectors.
Lists LGK16 model types, preferred uses, and detailed switching time parameters for various flame detection methods.
Key electrical and physical data for LOK16/LGK16, including voltage, fuse, weight, and protection rating.
Provides operating voltages, current limits, and maximum cable lengths for various flame detectors.
Illustrates circuits for measuring detector current for LOK16/RAR9 and LGK16/QRA5x, with important notices.
Shows the circuit diagram for measuring ionization probe current with the LGK16 control.
Explains how the self-checking flame supervision circuit operates and detects faults.
Lists the necessary conditions and checks required for initiating a burner startup sequence.
Describes the initial steps of the startup program, including prepurge and ignition timing.
Explains startup sequence steps and timing parameters for LGK16 with pilot burners.
Explains various fault symbols and their meanings, indicating startup abortions and lockouts.
Details lockout causes like loss of flame, air pressure failure, and specific LOK16 behavior after flame loss.
Instructions on how to reset the burner control after a lockout, emphasizing the 10-second limit for the reset button.
