Siemens LOGO! CSM 12/24 - Enabling Warnings and Loading KTP700 Project

4 Installation and Commissioning
House Control and Weather Sensors - LOGO! Set 11
Entry ID: 68585346, V2.1, 09/2018
26
 Siemens AG 2018 All rights reserved
No.
Action/response
WinCC Basic
9.
Proceed as follows:
1. Click on the "Alarm
window” to open its
properties.
2. Go to the "Properties" tab
and make sure that the
warning messages (here
for wind) which you have
configured, are enabled
under "Current alarm
states” and
"Unacknowledged alarms”.
10.
Once you have completed all
changes and modifications of
the warning messages, click
"Load” in the toolbar to load the
project to the KTP700.