Siemens MCP 398C Diagnostics Guide

08/2005 Overview of Alarms
2-15
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
1010 Channel %1 system error %2 action %3<ALNX>
Parameters: %1 = Channel number
%2 = System error number
%3 = Action number/action name
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
Reactions: - NC not ready.
- Interpreter stop
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con-
tinuation:
Switch control OFF - ON.
1011 Channel %1 %3 %4 system error %2
Parameters: %1 = Channel number
%2 = System error number
%3 = Optional parameter: Block number, label
%4 = Optional parameter: Action number, ....
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
Reactions: - Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con-
tinuation:
Clear alarm with the RESET key. Restart part program
1012 Channel %1 system error %2 %3 %4
Parameters: %1 = Channel number
%2 = System error number
%3 = Parameter1
%4 = Parameter2
Definitions: With this alarm, internal alarm states are displayed that, in conjunction with the trans-
ferred error number, provide information on the cause and location of the error.
Reactions: - Alarm display.
Remedy: Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Program Con-
tinuation:
Clear alarm with the Delete key or NC START.
1013 Channel %1 system error %2
Parameters: %1 = Channel number
%2 = System error number

Siemens MCP 398C Specifications

General

Brand	Siemens
Model	MCP 398C
Category	Control Systems
Language	English