EasyManuals Logo

Siemens MCP 398C Diagnostics Guide

Siemens MCP 398C
1002 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #905 background imageLoading...
Page #905 background image
08/2005 Overview of Alarms
2-905
© Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl/840D/840Di/810D Diagnostics Guide (DA), 08/2005 Edition
Definitions: The SSI transmission must be completed within an NC clock cycle. This is not possible
with its current parameterization.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: Either increase the clock cycle length of the NC or increase the SSI transmission rate
(MD_1030 $MD_ACTUAL_VALUE_CONFIG_DIRECT.Bits 14 and 15).
The following transmission rates are possible: 100 kHz, 500 kHz, 1 MHz and 2 MHz. Cau-
tion: It might be possible that the length of the encoder cable does not allow an increase
in frequency!
Program Con-
tinuation:
Switch control OFF - ON.
301718 Axis %1 drive %2 combination of motor/power section invalid
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: The motor cannot be operated with the power section selected.
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Remedy: • Check selection of power section.
• Check motor selection.
• Use valid power section.
Program Con-
tinuation:
Switch control OFF - ON.
301719 Axis %1 drive %2 power section data incomplete
Parameters: %1 = NC axis number
%2 = Drive number
Definitions: The data for the power section are incomplete:
• Operation of a power section with an FDD motor requires: MD_1178
$MD_INVERTER_DERATING_SYN (derating factor at 8kHz)
• Operation of a power section with an MSD motor requires: MD_1179
$MD_INVERTER_DERATING_ASYN (derating factor at 8kHz)
• Operation of a power section with a PE MSD motor requires: MD_1179
$MD_INVERTER_DERATING_ASYN (derating factor at 8kHz)
• MD_1175 $MD_INVERTER_THERM_CURR_ASYN (limit current power section for PE
MSD)
• MD_1177 $MD_INVERTER_RATED_CURR_ASYN (limit current power section for PE
MSD).
Reactions: - Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.

Other manuals for Siemens MCP 398C

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens MCP 398C and is the answer not in the manual?

Siemens MCP 398C Specifications

General IconGeneral
BrandSiemens
ModelMCP 398C
CategoryControl Systems
LanguageEnglish

Related product manuals