EasyManua.ls Logo

Siemens mobile phone - Battery Insertion and Charging

Siemens mobile phone
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
12.2.02 06-S46 Body.fm i 37 Am Engl, A31008-H5450-A5-1-4A19
Getting Started
Insert battery
Insert battery into the phone
(
and ).
Replace battery cover and push
gently in the direction of the
arrow
until it clicks.
Charge battery
The battery is not fully charged
when delivered. To charge your
phones battery:
Plug the supplied charger into the
device interface at the bottom of
the phone and plug the power
supply into the outlet. (Use only
the charger supplied with your
phone and charge for at least
two hours).
After charging, disconnect the
charger from the phone by
squeezing the top and bottom of
the charger cable and pulling it out
of your phone.
Charging
Your phone’s display shows the following:
s
When charging is in progress.
r
When charging is complete.
An empty battery is fully charged after
approximately two hours. Charging is only
possible when the temperature is between
41°F and 104°F (5°C and 40°C). (The
charge icon flashes as a warning when the
temperature is above or below the stated
values.) The voltage specified on the power
supply unit must not be exceeded.

Table of Contents

Related product manuals