Siemens MT50 - Wap Profile Settings

Setup
68
MT50 english, A31008-H5120-A1-1-7619 (4. März 2002, 11:00)
© Siemens AG 2001, I:\MOBIL\K45\MT50-Manta-altes Design\ENGLISCH\mitLG_Freigabe_020225\DRUCK\MT50_Setup.fm
§Menu§
¢
Setup
¢
Connectivity
¢
Select a function:
WAP profile settings
You can set or change up to 5 WAP
profiles (may be barred by the serv-
ice provider). The entries may vary
depending on your service provider.
To set a new profile:
MN
Select a profile.
§Options§ Open menu.
Change settings
Select and confirm.
MN
Select profile range and
make your settings/en-
tries field by field.
§Edit§ The entry card is dis-
played.
If necessary, check with your service
provider for details:
§Save§ The settings are stored
and the profile list is
shown.
Activate the set WAP pro-
file (p. 34).
WAP pa-
rameters
IP address: * Enter IP ad-
dress.
Port: * Enter port number.
Homepage: Enter homepage
(p. 32), if not set by the service
provider.
Linger time: Enter time in
seconds after which a connec-
tion should be terminated if no
input or data exchange takes
place.
*) depends on your service
provider, if necessary enter
2nd IP address and 2nd port
~
CSD
settings
(Circuit
Switched
Data)
Dial-up no.: Enter ISP
number.
Call type: Select ISDN or An-
alogue.
Login name: Enter login
name.
Password: Enter password
(shown as a series of aster-
isks).
GPRS
settings
(General
Packet
Radio
Service)
activated/deactivated: Acti-
vate/deactivate
APN: Enter the address of
your service provider.
Login name: Enter login
name.
Password: Enter password
(shown as a series of aster-
isks)
Note
As an alternative method to set/change a
new profile, you can use the browser menu:
† Call up the menu.
More ... Select.
WAP Profiles
Select.