Enhanced phone functions
97
Step by Step
Connecting parties
Select and confirm the option shown in the active con-
nections context menu. The other two parties are now
connected to one another. You can now hang up or dial
another number for instance.
or Connect by hanging up
Prerequisite: Connecting by hanging up is activated
(ask your service personnel) and "Toggle associate"
must be set to "Yes" (Æ page 98). Before you can be
connected by hanging up you must have toggled at
least twice (Æ page 67).
] or n Replace the handset or, if you are in speakerphone
mode, press the loudspeaker key. The other two parties
are now connected to one another.
Allowing call waiting
z
You can also configure this setting via the Web interface
Æ page 230.
Prerequisite: The option was programmed by your ad-
ministrator.
v Press the key shown until the "Settings" tab is active.
Confirm the option shown.
if nec.
j Enter and confirm the user password.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown.
Select and confirm the option shown in the context
menu.
Select and confirm the option shown.
Complete Xfer
If the Call waiting (second call) function is deacti-
vated, a caller hears the busy signal if you are al-
ready conducting a call.
User
Configuration
Incoming calls
Handling
Allow call waiting
Yes
Save & exit
To Next Page
Loading...
Need help?
General