To Next PageTo Next Page
Need help?Do you have a question about the Siemens QMX2.P33 and is the answer not in the manual?
General| Communication | KNX |
|---|---|
| IP Rating | IP30 |
| Display | LCD |
| Voltage | AC 24 V |
| Connection | Screw terminals |
| Device Type | Thermostat |
| Operating Voltage | AC 24 V |
| Mounting | Wall |
| Type | Room thermostat |
| Power consumption | ≤ 1.5 VA |
| Temperature setting range | 5 °C to 40 °C |
| Ambient temperature range | 0 °C to 50 °C |
| Protection class | II |
Introduction to wall-mounted sensors and room operator units with KNX PL-Link for Desigo Total Room Automation.
Measures room temperature/humidity, operates functions like fan control, and indicates environmental status.
Details the function of display elements and push buttons for device operation, settings, and navigation.
Illustrates the physical components: frame for panel mounting, base plate, and the room operator unit itself.
Summarizes product numbers (QMX2.P33, QMX2.P43) and their temperature/humidity sensor capabilities.
Lists compatible controllers for integration with Desigo TRA systems.
Provides access to essential documents like installation, CE, and environmental declarations.
Highlights crucial safety information regarding national regulations and potential hazards during operation.
Covers device power, plug & play, and recommended mounting positions for optimal performance.
Warns against incorrect AC 230V connections and stresses the importance of proper KNX PL-Link cable usage.
Outlines necessary steps before commissioning, including application download using SSA-DNT or ABT.
Details the automatic communication routine between the device and controller upon KNX PL-Link bus connection.
Step-by-step instructions for manual addressing, connection testing, and factory reset procedures.
Procedure to identify and assign a unique address to the device using commissioning tools.
Method to test the integrity and functionality of the KNX PL-Link connection.
Instructions for restoring the device to its original factory default configuration.
Explanation of the programming pin and service LED functions for mode management and diagnostics.
How to enter programming mode and assign device addresses using the programming pin.
Procedure for initiating and interpreting the results of the KNX PL-Link connection test.
Defines the response times for various button interactions: press, extended, and combination.
Guidelines for proper cleaning of the device using solvent-free agents and soft cloths.
Information on compliant disposal of the device as electronic waste according to EU directives.
Details on warranty coverage and limitations, particularly concerning third-party product usage.
Details operating voltage, power consumption, baud rate, and KNX PL-Link interface characteristics.
Specifies the measuring ranges and accuracy for both temperature and humidity sensors.
Defines housing protection (IP ratings), insulation class, and environmental conditions for operation and transport.
Lists compliance certifications including EU conformity, RCM, and IC standards.
Covers UL, FCC compliance, and environmental compatibility, including interference management.
Basic information about the device, such as its color and weight.
Diagram showing the KNX PL-Link plug and the function of each pin for connection.
Details the tool plug and the pin assignments for the RJ45 tool cable used for service.
Illustrates the operational connection between the room operator unit and the controller via KNX.
Explains how to connect the ABT tool for application loading and device service.
Provides precise measurements of the device and its mounting plate for installation planning.
