Operating Instructions
RDE10.1DHW
RDE10.1DHW is a temperature controller that allows you to set the ideal room temperature at the time you want. In addition, it
offers independent control of DHW. There are 2 different switching patterns available: 1 for controlling the heating output and 1
for controlling DHW. Both can be set independently to meet your specific needs. You can either rely on the factory settings or
make your own settings that suit your personal needs.
Operation
Replace batteries
Warmer / colder
setting the
temperature setpoints
and the time of day
Button for operating
mode selection:
Auto ( )
,
Normal operation ( )
,
Energy saving mode ( )
,
Frost protection mode ( )
Batteries
3038Z02en
Display
Normal operation
Energy saving mode
DHW control
Weekday (1 = Monday / 7 = Sunday)
Measured room temperature,
setpoints and parameters
Real time from 00:00 to 23:59
AM / PM (for 12-hour mode)
Switching pattern
for DHW and heating
Confirmation
Settings
Time of day
Heating program
1...7
Weekday
1.5V
'AA'
1.5V
'AA'
+-
Auto DHW program
Normal operation
Energy saving mode
Heating ON
Automatic mode /
switching pattern settings
Frost protection mode
Actual room temperature symbol
°C
Temperature
Auto DHW
activated
Commissioning with quick startup
The controller is supplied with factory-set switching patterns, switching times and temperatures. To commission it,
proceed as follows:
1.5V 'AA'
1.5V 'AA'
Remove the black transit tab from the 2 included batteries. Check to see if the battery holder is in its correct position.
The controller switches itself on.
Press button and then
+
-
to set the current time of day and confirm by pressing .
1...7
Press button
1...7
and then
+
-
to set the current weekday and confirm by pressing
(1 = Monday through 7 = Sunday).
Press button for the operating mode to select the required operating mode (default mode is automatic mode).
The display shows the
symbol when powered up. The sequence of operating mode is started from automatic ,
to normal
, energy saving and frost protection , or vice versa.
Press DHW button to select the required DHW operating mode (default mode is Auto DHW ).
The display shows the
symbol when powered up. The sequence of DHW operating mode is started from
automatic
, to permanently OFF and permanently ON , or vice versa.
1/4 Operating Instructions CE1B3038en / 19.10.2005 Building Technologies / HVAC Products
To Next Page
Need help?
General
