Siemens RDE10.1DHW - User Manual

3
038
Room Temperature Controller
with 7-Day Time Switch and
independent DHW Control
RDE10.1DHW
• 2-position control with ON / OFF output for heating
• Independent ON / OFF control of DHW
• Operating modes: Auto, normal operation, energy saving and
frost protection
• 7-day time switch and manual control
• Battery-powered DC 3 V (2 x 1.5 V AA)
Use
The RDE10.1DHW is used for the control of the room temperature in heating systems
with independent control of DHW.
Typical applications:
• Residential apartments
For the control of the following plant components and of DHW:
• Thermal valves or zone valves
• Gas or oil burners
• Fans
• Pumps
• Heat exchanger
• Continuous-flow water heater
• Small water heating systems
CE1N3038en
20.10.2005
Building Technologies
HVAC Products

Summary

Product Overview and Applications

Functions and Operating Modes

Operating Modes Overview

Explains auto, normal, energy saving, and frost protection modes.

7-Day Time Switch

Describes automatic mode changes based on the programmed schedule.

DHW Control

Highlights independent control capabilities for Domestic Hot Water.

Display Information

Ordering and Mechanical Design

Mechanical Design and Legend

Describes the controller's physical construction and explains its components.

Installation, Maintenance, and Calibration

Mounting and Commissioning

Guidance on proper installation location, mounting, and initial setup.

Technical Data

Power Supply and Control Outputs

Operational Data

Siemens RDE10.1DHW Specifications

General

Frequency	50/60 Hz
Control Output	Relay
Accuracy	±1 °C
Degree of Protection	IP30
Display	LCD
Control Performance	PI control
Digital Input, Number	1
Type	Temperature Controller
Product Type	Temperature Controller
Switching Current	8 A
Protection Class	II
Ambient Temperature Range	0 - 50 °C
Hysteresis	0.5 K
Mounting	Wall