Siemens RDG100KN - Engineering and Commissioning; Mounting and Installation

8 / 86
Siemens RDG100KN Basic documentation CE1P3191en
Building Technologies Summary 22 Jun 2010
 Room temperature control via built-in temperature sensor or external room
temperature / return air temperature sensor
 Changeover between heating and cooling mode (automatic via local sensor or
bus, or manually)
 Selection of applications via DIP switches or commissioning tool (ACS700).
Parameter and application download with ETS3 will be implemented later
 Select operating mode via operating mode button on the thermostat
 Temporary Comfort mode extension
 1- or 3-speed fan control (automatically or manually)
 Display of current room temperature or setpoint in °C and/or °F
 Minimum and maximum limitation of room temperature setpoint
 Button lock (automatically or manually)
 3 multifunctional inputs, freely selectable for:
– Operating mode switchover contact (keycard, window contact, etc.)
– Sensor for automatic heating / cooling changeover
– External room temperature or return air temperature sensor
– Dew point sensor
– Electric heater enable
– Fault input
– Monitor input for temperature sensor or switch state
 Advanced fan control function, e.g. fan kick, fan start, selectable fan operation
(enable, disable or depending on heating or cooling mode)
 “Purge” function together with 2-port valve in a 2-pipe changeover system
 Reminder to clean fan filters
 Floor heating temperature limitation
 Reload factory settings for commissioning and control parameters
Functions