en Before using for the first time
28
Before using for the first time
Before using for the
first time
Before using for the first time
Configure the settings for initial start-
up.
Performing initial start-up
On initial start-up or after a reset to
the factory settings, you will need to
make settings.
Requirement:"The appliance has
been installed and connected."
→Page13
1.
"Add special salt." →Page29
2.
"Add rinse aid." →Page31
3. "Switch on the appliance."
→Page37
4. "Set the water softening system."
→Page29
5. "Set the amount of rinse aid to be
dispensed." →Page31
Tip:You can change these settings
and other "Basic settings"
→Page39 at any time.
Water softening system
Water softening system
Water softening system
Hard water leaves limescale on the
tub and tableware and parts of the
appliance may become blocked.
To ensure good dishwashing results,
you can treat the water with special
salt and the water softening system.
To avoid damage to the appliance,
water with a hardness above 9 °E
must be softened.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected
here.
You can find out how hard your water is from your local water company or by
using a water hardness tester.
Water hardness °E Hardness range mmol/l Setting value
0 - 8 Soft 0 - 1.1 H:00
9 - 10 Soft 1.2 - 1.4 H:01
11 - 12 Medium 1.5 - 1.8 H:02
13 - 15 Medium 1.9 - 2.1 H:03
16 - 20 Medium 2.2 - 2.9 H:04
21 - 26 Hard 3.0 - 3.7 H:05
27 - 38 Hard 3.8 - 5.4 H:06
39 - 62 Hard 5.5 - 8.9 H:07
Note:Set the water hardness determ-
ined on your appliance.
→"Setting water softening system",
Page29
With a water hardness of 0 - 8°E
you can dispense with special salt
and switch off the water softening
system.
→"Switching off water softening sys-
tem", Page30
To Next Page
Loading...
Need help?
General
