EasyManuals Logo

Siemens S Series User Manual

Siemens S Series
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
Troubleshooting en
47
Fault Cause Troubleshooting
Appliance door opens too
wide when activated.
Door is not correctly adjus-
ted.
Adjust the appliance door as de-
scribed in the installation instruc-
tions.
Error code / Fault display / Signal
Fault Cause Troubleshooting
E:12 lights up. Heating element is furred
up.
1. Descale the appliance.
2. Operate the appliance with the Wa-
ter softening system.
E:14 lights up. Water protection system is
activated.
1. Turn off the water tap.
2. Call "Customer Service"
→Page59.
E:15 lights up. Water protection system is
activated.
1. Turn off the water tap.
2. Call "Customer Service"
→Page59.
E:16 lights up. Water is continuously run-
ning into the appliance.
1. Turn off the water tap.
2. Call "Customer Service"
→Page59.
E:18 or indicator for water
supply lights up.
Supply hose is kinked.
Install the supply hose without
kinks.
Water tap is turned off.
Turn on the water tap.
Water tap is jammed or
furred up.
Turn on the water tap.
The flow rate must be at least 10 l/
min when the water supply is open.
Filter in the water supply is
blocked.
1. Switch off the appliance.
2. Pull out the mains plug.
3. Turn off the water tap.
4. Unscrew the water connection.
5. Remove the filter from the supply
hose
6. Clean the filter.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens S Series and is the answer not in the manual?

Siemens S Series Specifications

General IconGeneral
TypeDishwasher
BrandSiemens
SeriesS Series
Water Consumption9.5 liters per cycle
Noise Level44 dB
Programs6
Drying SystemZeolith

Related product manuals