en Troubleshooting
52
Fault Cause Troubleshooting
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
▶
Position tableware at an angle.
→"Arrange tableware", Page36
▶
Use rinse aid.
→"Rinse aid", Page31
▶
Set the water softening system
higher.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page32.
▶
Clean the appliance mechanically.
White coating is deposited in
the appliance interior.
1. Set the water softening system cor-
rectly.
In most cases you will need to in-
crease the setting.
2. Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser
tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page32.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°E
(8,9mmol/l).
▶
Set the "Water softening system"
→Page28 to the water hardness
or add special salt.
3in1/organic/eco detergent
is not effective enough.
▶
Set the "Water softening system"
→Page28 to the water hardness
and use separate detergents (pro-
prietary detergent, special salt,
rinse aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change "Detergent "
→Page32.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
▶
Adjust the sensitivity of the sensors.
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
To Next Page
Loading...
Need help?
General
