6.4 Tamper Function
The tamper is very important for the protection of the mounting. There are two
types of tamper switches:
● Opening the lid (see item 17 in the
AP Controller Diagram
)
● Removing unit from the wall ( see item 25 in the
AP Controller Diagram
)
The wall tamper requires that the unit is properly fixed to wall with a screw. If the
unit is removed, the plastic plug (which presses on the tamper switch) breaks, and
the tamper alarm becomes active.
6.5 Configuration
The ACC-AP must be configured locally with the parameters for communication to
the SiPass integrated computer where the overall system settings can be made. If
a reader is connected to the ACC-AP and the system settings are configured, a
card or tag could be used for verifying the functions.
For Firmware configuration and more information, see the
Controller and Device
Installation Guide
in the SiPass integrated software bundle.
To Next Page
Loading...
