Siemens SC Series User Manual

en Basic operation
30
Starting the programme
▶
Press .
a The programme has ended when
the display shows "0:00".
Notes
¡ You can only change a pro-
gramme when running if you can-
cel it.
→"Terminate programme",
Page30
¡ The appliance switches off auto-
matically 1minute after the end of
the programme to save energy. If
you open the appliance door im-
mediately after the programme has
ended, the appliance will switch off
after 4 seconds.
Interrupting programme
Note:When you open the appliance
door once the appliance has heated
up, leave the door slightly ajar for a
few minutes and then close it. This
will help prevent excess pressure
building up in the appliance and stop
the appliance door bursting open.
1. Press ⁠.
a The programme is saved and the
appliance switches off.
2. Press to resume the pro-
gramme.
Terminate programme
To end a programme early or to
switch from a programme that has
already started, you will need to ter-
minate it first.
▶
Press for approx.
3seconds.
a The programme is terminated and
ends after approx. 1minute.
Switching off appliance
1. Please note the information on
Safe use →Page10.
2. Press .
3. To prevent damage from dripping
water, turn the water tap off tight
(not applicable to appliances with
Aqua-Stop).
Tip:If you press during the wash
cycle, the programme currently run-
ning will be interrupted. When you
switch the appliance back on, the
programme continues automatically.

Siemens SC Series Specifications

General

Brand	Siemens
Model	SC Series
Category	Dishwasher
Language	English