Configuring with Web Based Management
6.9 "Security" menu
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 08/2018, C79000-G8976-C267-13
367
●
With this button, you can test whether or not the specified RADIUS server is available.
The test is performed once and not repeated cyclically.
●
Shows whether or not the RADIUS server is available:
– Not reachable
The IP address is not reachable.
The IP address is reachable, the RADIUS server is, however, not running.
– Reachable, key not accepted
The IP address is reachable, the RADIUS server does not, however accept the shared
secret.
– Reachable, key accepted
The IP address is reachable, the RADIUS server accepts the specified shared secret.
Steps in configuration
Entering a new server
1. Click the "Create" button. A new entry is generated in the table.
The following default values are entered in the table:
– RADIUS Server Address: 0.0.0.0
– Server Port: 1812
– Max. Retrans.: 3
– Primary server: No
2. In the relevant row, enter the following data in the input boxes:
– RADIUS Server Address
– Server Port
– Shared Secret
– Shared Secret Conf
– Max. Retrans.: 3
– Primary server: No
3. If necessary check the reachability of the RADIUS server.
4. Click the "Set Values" button.
Repeat this procedure for every server you want to enter.
To Next Page
Loading...
