2-4
C7-621 / C7-621 AS-i Control Systems
C79000-G7076-C622-01
If a configuration is already loaded, you can download a new configuration
following the same procedure as explained in “No Configuration Loaded”.
If the standard screen or the function mentioned above is not available in the
currently loaded configuration, you must remove the existing configuration
using the memory reset function before you can load a new configuration.
For detailed information about the memory reset function, refer to Section
2.4.
To reset the memory on the OP:
1. Turn off the C7.
2. Press and hold the keys
simultaneously.
3. Turn on the power for the C7.
4. The remaining steps are analogous to “No Configuration Loaded”.
Reloading an OP
Configuration
Startup