Siemens SIMOREG DC Master 6RA7018-6DS22 - Page 394

Parameter list 02.00
11-2 SIEMENS AG 6RX1700-0AD76
SIMOREG DC Master Operating Instructions
U005 - U007 Password protection, key/lock mechanism [SW 1.7 and later]
U116 - U118 Binector / connector converter for the serial interfaces [SW 1.4 and later]
U607 - U608 Setpoint reduction [SW 1.6 and later]
U619 Definition of the function of the relay output at terminals 109 / 110 [SW 1.7 and later]
U651 - U657 Starting pulse speed controller [SW 1.7 and later]
U660 - U668 Evaluation of a 4-step master switch for cranes [SW 1.7 and later]
U710 - n739 Configuration of supplementary boards in board locations 2 and 3
U740 - U753 Configuration of the SIMOLINK board [SW 1.5 and later]
U755 - n770 Configuration of the EB1 expansion board [SW 1.5 and later]
U773 - n788 Configuration of the EB2 expansion board [SW 1.5 and later]
U790 - n795 Configuration of the SBP pulse encoder board [SW 1.5 and later]
U800 - n813 Configuration of paralleling interface
U840 Simulation operation [SW 1.7 and later]
n845 - n949 Parameters for SIMOVIS
n957 - n959 Parameters for SIMOVIS
n980 - n999 List of existing and modified U and n parameters
Parameters for technology software in the basic converter, S00 option
("freely assignable function blocks")
Range of parameter
numbers
Function
n010 - n023 Displays
U099 Settable fixed values [SW 1.8 and later]
U100 - U107 Triggering of faults and alarms
U110 - U115 Connector/binector converters, binector/connector converters
U120 - U171 Mathematical functions
U172 - U173 Processing of connectors (averager) [SW 1.8 and later]
U175 - U218 Limiter, limit-value monitors
U220 - U259 Processing of connectors
U260 - U299 Integrators, DT1 elements, characteristics, dead zones, setpoint branching
U300 - U303 Simple ramp-function generator
U310 - U313 Multiplexer [SW 1.8 and later]
U318 - U411 Logic functions
U415 - U474 Storage elements, timers and binary signal selector switches
U480 - U512 Technology controller
U515 - U523 Velocity/speed calculators
U525 - U529 Variable moment of inertia [SW 1.8 and later]
U530 - U545 PI controller [SW 1.8 and later]
U550 - U554 Closed-loop control elements [SW 1.8 and later]
U950 - U952 Sampling times
U960 - U969 Altering the processing sequence of function blocks
U977 - n978 Enabling of technology software in basic unit, S00 option ("freely assignable function blocks")