Meaning of the LED displays
This
table describes the LEDs and their meaning. The PN and
SY
LEDs have no function for
SIMOTION D4x5-2 DP.
Table 3-5 Error and status displays
LED Meaning
RDY Operating states of SIMOTION D incl. SINAMICS Integrated.
RUN User program is running
STOP No user program is running. The technology packages are not active
SU/PF The technology packages are active. The user program is not active
SF An error state of the SIMOTION D4x5‑2
DP State of the PROFIBUS DP interface
DP/MPI State of the PROFIBUS DP/MPI interface
PN State of the onboard PROFINET IO interface (X150)
SY/MT - Synchronization status (SY) of the onboard PROFINET IO interface (X150)
- Maintenance status (MT) of the D4x5‑2 (currently without function)
OPT State of the option module (if available).
Note
While the SIMOTION D4x5‑2 is ramping up, all LEDs are briefly illuminated in yellow.
7-segment display
The 7-segment display provides further status information in addition to the LED displays.
The status "6" and a flashing "." indicate that the D4x5‑2 has ramped up and communication
has been established to the SINAMICS Integrated.
Additional information
You
can perform a detailed diagnosis with a PG/PC and the engineering system. Information
on the
Diagnostics
via LED displays can also be found in the
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual and in the online help of this section via the
link under the
Instructions
menu.
Operator control (hardware)
3.3 7-segment and LED displays
SIMOTION D4x5-2
50 Manual, 04/2014
To Next Page
Loading...
Need help?
General
