Commissioning (software)
6.20 Configuring Safety Integrated functions
SIMOTION D4x5-2
294 Commissioning and Hardware Installation Manual, 02/2012
Required hardware
Where safety functions are controlled via the TM54F or via PROFIBUS/PROFINET with
PROFIsafe, at the very least the following hardware versions must be used:
Table 6- 16 Required hardware versions
Module Order number Required product version
SIMOTION D425-2 DP 6AU1425-2AA00-0AA0
1)
SIMOTION D425-2 DP/PN 6AU1425-2AD00-0AA0
1)
SIMOTION D435-2 DP 6AU1435-2AA00-0AA0
1)
SIMOTION D435-2 DP/PN 6AU1435-2AD00-0AA0
1)
SIMOTION D445-2 DP/PN 6AU1445-2AD00-0AA0 C
SIMOTION D455-2 DP/PN 6AU1455-2AD00-0AA0 C
SIMOTION CX32-2 6AU1432-2AA00-0AA0 B
CBE30-2 6FC5312-0FA00-2AA0
1)
1)
The information was not available at the time the documentation was published. Current
information can be found at
(http://support.automation.siemens.
com/WW/view/en/27585482).
The hardware requirements of the drive components can be found in the
SINAMICS S120
Safety Integrated
Function Manual.
To Next Page
Loading...
