Mounting kit to increase the degree of protection to IP20
Hardware Installation Manual, 02/2021, A5E34871844B
3
Preface
Failure to observe the general safety instructions and residual risks
If the general safety instructions and remaining risks are not observed, accidents can occur
involving severe injuries or death.
• Comply with the general safety instructions in Chapter 1 of the SINAMICS DCM DC
Converter Operating Instructions.
• Take special care to ensure that the unit is brought into a no-voltage condition and
locked out before carrying out any work.
If you want additional information or if exceptional problems arise that are not addressed in
sufficient detail in this Hardware Installation Manual, you can request the required
information from your local Siemens office.
We would also like to point out t
hat the contents of this Hardware Installation Manual are
neither part of nor modify any prior or existing agreement, commitment or contractual
relationship. The Purchase Agreement contains the complete and exclusive obligations of
Siemens, including the w
arranty provisions. Any statements contained in this Hardware
Installation Manual neither expand nor restrict the scope of these contractual warranty
conditions.
Service
You can find information on our services and regional contact persons in the Internet -
(https://support.industry.siemens.com/sc/ww/en/sc)
Technical Support
Our technical support can provide you with technical assistance for products, systems, and
solutions:
Service (https://support.industry.siemens.com/sc/ww/en/sc)
To Next Page
Loading...
Need help?
General
