Commissioning
4.5 Commissioning with STARTER
Frequency inverter
60 Operating Instructions, 08.10. 2008, t.b.d.
● Click "Change and test..." to set up the PG/PC interface.
PG/PC - Set interface
● Select "PC COM-Port (USS)" from the list and click on "Properties …"
Figure 4-6 Setting the USS interface
● If "PC COM-Port (USS)" is not available, click on "Select …" to install the "PC COM-Port
(USS)" interface as shown in the "Install/Remove Interfaces" dialog box.
Figure 4-7 Installing the USS interface
To Next Page
Loading...
