Siemens SINUMERIK 840 - Page 144

07.90 5 Measuring Cycles for Milling Machines and Machining Centres
5.2.3 L977 Measure slot (paraxial)
Example: Measure slot with measuring cycle L977
(Data as in Fig. 5.11)
%MPF 9774
:
Machining program
:
N500 G54 T200 T number probe; select ZO
N505 G00 X150 Y130 Position probe in Y axis at slot
centre point and in the X axis
at measuring position
N510 Z40 D99 Position Z axis inside slot
N515 R10=2030 R11=10 R22= 1 R23=11 Define parameters for measuring cycle
R25=0 R27=1 R28= 1 R29=3
R30=2 R33=0.002 R34= 0.03 R36=1
R37=0.06 R40=0.03 R41=-0.03 R42=100
N525 L977 Cycle call for slot measurement in Y
N530 G00 Z160 Withdraw Z axis from slot
N535 M30
© Siemens AG 1990 All Rights Reserved 6FC5197- AB70 5–25
SINUMERIK 840/850/880 (BN)