Need help?Do you have a question about the Siemens Sinumerik 840D Series and is the answer not in the manual?
General| Axes | Up to 31 axes |
|---|---|
| Power Supply | 24 V DC |
| Control Type | CNC |
| Interface | Ethernet, PROFIBUS |
| Display | TFT color display |
| PLC | Integrated PLC (programmable logic controller) |
| Operating Temperature | 0°C to 45°C |
| Relative Humidity | Up to 95% (non-condensing) |
| Max. Number of Channels | Up to 10 channels |
Details of the edition and previous editions, including status codes.
Describes the content of the manual, covering NCK, PLC, and SIMODRIVE alarms.
Outlines the three levels of SINUMERIK documentation: General, User, Manufacturer/Service.
Provides contact information for technical support for questions and assistance.
Lists system errors that are considered system errors.
Provides a general overview of alarms.
Explains important notices and ordering data supplements.
Describes different levels of warnings: Danger, Warning, Caution, and Notice.
To Next Page
