V
Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA) – 11.02 Edition
11.02 Preface
Preface
Structure of the
documentation
The SINUMERIK documentation is divided up into three levels:
• General documentation
• User documentation
• Manufacturer/Service documentation.
This manual is intended as a work of reference. It allows the operator at the machine tool:
- To correctly assess special situations when operating the machine.
- To ascertain the reaction of the system to the special situation.
- To utilize the possibilities for continued operation following the special situation.
- To follow references to other documentation containing further details.
Scope This manual describes the alarms from the NC kernel (NCK) area, the PLC and the
SIMODRIVE 611D drive.
Other alarms can occur from the MMC (Man-Machine Communication) areas. They are
displayed on the operator panel in the form of self-explanatory text. They are documented
in the section on MMC messages.
For special situations in conjunction with the integrated PLC, please refer to the SIMATIC
S7-300 documentation.
Please contact your local SIEMENS office for more detailed information about documen-
tation on SINUMERIK 840D/810D and publications which apply to all SINUMERIK con-
trols.
Target group This documentation is intended for manufacturers of machine tools with SINUMERIK
840D or SINUMERIK 810D and SIMODRIVE 611D.
Hotline If you have any questions, please get in touch with our hotline:
A&D Technical Support
Tel.: ++49-(0)180-5050-222
Fax: ++49-(0)180-5050-223
e-mail: adsupport@siemens.com
If you have any questions about the documentation (suggestions, corrections), please fax
or e-mail us at the following addresses:
Fax: ++49-(0)9131-98-2176
email: motioncontrol.docu@erlf.siemens.de
Fax form: See the reply form at the end of the document.
Internet address http://www.ad.siemens.de/sinumerik
To Next Page
Loading...
Need help?
General
