Siemens SiPass integrated

Alarm Class
4
A6V11144326
17 | 66
Type
Status
Description
Input tamper
The input or wiring has been tampered with.
Input open
The input is an open circuit.
Card limit reached
The unit’s card limit has been exceeded
Passback tamper
A supervised passback input has detected a
tamper.
Input Disabled
The input has been disabled.
Input Faulty
The input is not recognised
Input Physically disabled
at FLN device
The input has been physically disabled by
setting jumpers on the device.
Sintony Input Unsealed
The Sintony input is active and may prevent
the area from being armed (depending on
the configuration)
Intrusion Area
Intrusion Area Armed
The intrusion area has been armed.
Normal
An intrusion area that was in an alarm state
has now returned to the normal state.
Arming Action Complete
An attempt to arm a dependant intrusion
area was made. However, other areas
dependant on this area are still unarmed.
Intrusion Area Part Armed
The intrusion area has been part armed.
Intrusion Area Part Armed
B
The SPC intrusion area has been part armed
B. (SPC only)
Intrusion Area Disarmed
The intrusion area has been disarmed.
Alarm
An armed intrusion area has been violated.
Arming Failed
An attempt to arm an intrusion area has
failed.
OPC Point
Normal
The OPC Point is in a normal state.
Acked Alarm
The OPC Point is in alarm, but the alarm has
been acknowledged.
Unacked Normal
The OPC Point is in a normal state after an
alarm, but has not been acknowledged.
Disabled
The OPC Point is disabled.
Alarm
The OPC Point is in alarm.
Output
Locked
The output is secure.
Output Enabled
The output has been enabled.
Unlocked
The output is not secure.
The output is not secure.
The output has been disabled.
Output Open
Output is in an open status
Unit
Communication back
Communication between the unit and the
server is active.
Unit reset
A unit has been reset.
Unit Tamper inactive
The tamper input on a unit is inactive
Power Returned
Power has been applied to the unit.