Siemens SiPass integrated

Alarm Class
4
16 | 66
A6V11144326
Type
Status
Description
Image
Verification
Privilege
Normal
The operator has privileges to allow or deny
entry based on visual identification of live
and database cardholder images.
Operator No IV privilege
The operator does not have privileges to
allow or deny entry based on visual
identification of live and database cardholder
images.
Input
Passback
A passback button has been activated.
Normal
The input is normal.
Door closed
The door is closed.
Fire override off
The fire override is disabled.
Battery OK
The unit’s battery output voltage is above
11.5V.
AC power back
The unit’s AC power supply has been
restored. The unit will cease to draw power
from the battery backup.
Input closed
The input has been closed.
Input Enabled
The input has changed state and is now
enabled.
Input Physically Enabled
at FLN device
The Fire Override on the device has been
enabled physically.
Input tamper or fault
cleared
The input tamper state has been cleared /
fixed.
Sintony Input Sealed
The Sintony input is inactive and the input
area could be armed.
Sintony Input Isolated
Overrides the Sintony Input Unsealed
therefore allows the area to be armed and
also disables the processing of this input in
the intrusion system.
Alarm
The input is in alarm.
Tamper
A monitored input or wire has changed state
and is either short or open circuit.
Door held
The door is being held open. (The door has
remained open after the latch time has
expired).
Door forced
The door has been forced (opened without
gaining valid access).
Fire override on
The fire override has been enabled.
Battery failed
The unit’s battery voltage has dropped below
11V. The battery circuit will be broken,
forcing a loss in communications. However,
the database memory is retained.
Battery low
The unit’s battery output voltage has
dropped below 11.5V.
AC power failed
The unit’s AC power supply has failed. The
battery backup will be switched on
automatically.