Disables the input, if it is currently enabled, until
the next change in Time Schedule.
Enables the input, if it is currently disabled, until
the next change in Time Schedule.
Sends a pulse command to the selected Input.
This is only applicable for Sintony input points of
type “Serial Coms Input”
Set the input to state Alarm.
Set the input to state Normal
Arms the selected intrusion area.
Disarms the selected intrusion area.
Manually isolates a point from an intrusion area,
excluding that point from a seal check when the
area is armed.
Arms inputs which are marked as Part Arm.
Part Arm B Intrusion
Area
Arms inputs which are marked as Part Arm
B.(SPC only)
Intrusion Area
Point Group
Same as Intrusion
Area Points
Allows a message to be forwarded to one or
more pagers if the host event task has been
triggered.
Sends details of the trigger to all OPC
connections defined in the
Components
dialog.
Allows a message to be forwarded to one or
more email addresses if the host event task has
been triggered.
Allows access at an output point. (Operates in
the same way as if a cardholder used their card
to gain valid access at the same point). The
output point will only be activated (unlocked) for
the pre-set latch time.
Locks the output temporarily (if the output is
currently unlocked) until the next change in Time
Schedule.
Enter the Time into the Data field, using the
format HH:MM:SS.
Unlocks the output temporarily (if the output is
cur-rently locked) until the next change in Time
Schedule.
Enter the time into the Data field, using the
format HH:MM:SS.
The state of the output will be toggled to the
reverse state.
To Next Page
Loading...
