Siemens SiPass integrated

Controller Event Tasks
Sources
8
44 | 66
A6V11144326
Type
State (trigger)
Description
Host Verify Message
An event task has been triggered when a
request for Image Verification has been sent
from an access point to SiPass integrated.
Host Verify Timeout
Message
An event task has been triggered when a card
has been badged at an image verification
access point, and the operator has not
responded within the defined Host Verify
Timeout.
Host Verify View
Only Message
An event task has been triggered when a view-
only image verification event has occurred at
an access point.
No Entry
An event task is triggered if the access point is
set to “Delayed Reporting” mode and a valid
card has been badged at a reader, but the
door monitor has not registered passage
through the door.
Passback Error
An event task has been triggered when a card
has been badged out of sequence at an
access point configured for Global Anti-
Passback.
PIN Error
An event task has been triggered when an
incorrect PIN for that card number has been
entered at an access point.
PIN Error Disabled
An event task has been triggered when a card
has been voided after the cardholder has
made three consecutive incorrect PIN entries
in the facility.
Point Disabled
An event task has been triggered when an
access point has been disabled.
Soft Anti-Passback
error
An event task has been triggered when a soft
Anti-Passback error has occurred.
Soft Perimeter
Violation
An event task has been triggered when a Soft
perimeter violation has occurred.
Time Schedule
Violation
An event task has been triggered when a card
was rejected because it has access to this
door but not at the current time
Timed Re-Entry
Error
An event task has been triggered when a
cardholder has attempted to re-enter an area
(set to Timed Re-Entry Anti-Passback mode)
before their permitted re-entry time.
Controller
About to Reset
ACC is about to reset.
AC Power Fail
An event task has been triggered when a
controller event task is triggered when the
mains power to the ACC fails.
AC Power OK
An event task has been triggered when a
controller event task is triggered when the
mains power to the ACC has been restored.
Audit Trail Disabled
An event task has been triggered when a
controller event task is triggered when Audit
Trail reporting from the ACC to the Server is
disabled.