Siemens SiPass integrated

Controller Event Tasks
Sources
8
A6V11144326
47 | 66
Type
State (trigger)
Description
Door Opened
An event task is triggered when a door monitor
has registered that a door has been opened
for longer than the Input Delay time.
Door Tamper
An event task is triggered when a device has
registered that a supervised door monitor input
has been tampered with.
Input Alarm
An event task is triggered when an input point
has entered an alarm state.
Input Faulty
An event task is triggered when an input point
has become faulty.
Input Isolated
An event task is triggered when an input point
has been iso-lated.
Input Normal
An event task is triggered when an input point
has been re-stored to a normal state.
Input Physically
disabled at FLN
device
The input has been physically disabled by
setting jumpers on the device.
Input Physically
enabled at FLN
device
The Fire Override on the device has been
disabled physically.
Input Sealed
An event task is triggered when an input point
has been sealed.
Input Tamper
An event task is triggered when a device has
registered that a supervised input point has
been tampered with.
Input tamper or fault
cleared
The input tamper state has been cleared /
fixed.
Input Unsealed
Input has failed a seal check when arming an
Intrusion Area.
Pass back Tamper
An event task is triggered when a device has
registered that a supervised request-to-exit
input has been tampered with.
Pass back Trigger
An event task is triggered when a passback
input has been activated.
Intrusion Area
Alarm
An event task will be triggered when the
intrusion area enters an alarm state.
Armed
An event task will be triggered when the
specified intrusion area becomes armed.
Arming Action
Complete
An event task will be triggered when an
attempt has been made to arm a dependant
area, but not all areas to which it belongs have
been armed first.
Arming Failed – Input
X in Alarm
An event task will be triggered when the
arming of an intrusion area fails due to an
input that is currently in an alarm state.
Disarmed
An event task will be triggered when the
specified area has been disarmed.
Entry Delay Timer
Started
An event task will be triggered when the entry
delay timer has started.