Page 208 SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS A5E33329501
mmmmm
Parameters
3.3.3.9. Acknowledged
Acknowledges the current maintenance reminder.
To acknowledge a reminder via SIMATIC PDM:
a) Open the menu View – Device Status and click on the tab
Maintenance.
b) In the Device Lifetime section, click on Acknowledge Warnings.
To acknowledge a reminder via the local push buttons:
a) Navigate to Maintenance and Diagnostics (3.) > Maintenance (3.3.)
> Remaining Device Life (3.3.3.) > Acknowledged (3.3.3.9.), and
RIGHT arrow to acknowledge the reminder.
3.3.4. Remaining Sensor Life
The device monitors the predicted lifetime of the sensor (the components
exposed to the vessel environment). You can modify the expected sensor
lifetime, set up schedules for maintenance reminders, and acknowledge them.
To access these parameters via SIMATIC PDM:
• Open the menu Device – Maintenance and select the Remaining Sensor
Lifetime tab. (For more details see
Maintenance
in LUT400
Communications manual.
1
)
Time Units
Allows you to set the desired units.
Notes:
• Four sets of parameters allow you to monitor the Device/Sensor Lifetimes
and set up Maintenance/Service schedules, based on operating hours
instead of a calendar-based schedule. See also Remaining Device Life
(3.3.3.), Service Schedule (3.3.5.), and Calibration Schedule (3.3.6.).
• Performing a reset to Factory Defaults will reset all the Maintenance
Schedule parameters to their factory defaults.
• The device operates in years. To view Remaining Sensor Lifetime
parameters in hours or days (only via SIMATIC PDM, PACTware FDT, and
AMS) see Lifetime Expected (3.3.4.1.).
1.
Communications for SITRANS LUT400 (HART) Manual (7ML19985NE01)
Options
a
a.
Units are selectable only via SIMATIC PDM, PACTware FDT, and AMS.
HOURS
DAYS
* YEARS
To Next Page
Loading...
