Siemens SN45EW69CS - Changing Basic Settings; Changing Basic Settings, Page; Remote Start, Page

Basic settings en
39
Basic setting Display text Selection Description
autoOpen Dry o:02
1
o:00 - o:02 Activate or deactivate automatic
opening of the appliance door during
the drying phase.
The following settings are possible:
¡ With the "o:00" setting, automatic
door opening is deactivated in all
programmes.
¡ With the setting "o:01" automatic
door opening is activated in all
programmes.
¡ With the "o:02" setting, automatic
door opening is only activated in
the Eco 50° programme.
→"autoOpen Dry", Page13
Wi-Fi Cn:00
1
Cn:00 - Cn:01 Switch the wireless network connec-
tion on or off.
Level "Cn:00" switches the wireless
network connection off.
Remote start rc:01
1
rc:00 - rc:02 Activate or deactivate remote start.
The following settings are possible:
¡ With the "rc:00" setting, remote
start is permanently deactivated.
¡ With the "rc:01" setting, remote
start can be selected via the re-
mote start button.
→"Remote start ", Page41
¡ With the "rc:02" setting, remote
start is permanently activated.
Factory setting rE: Start with Restore changed settings to the fact-
ory settings.
The settings for initial start-up must
be configured.
1
Factory setting (may vary according to model)
Changing basic settings
1. Press ⁠.
2. To open the basic settings, press
for 3 seconds.
a The display shows H:xx.
a The display shows ⁠.
3. Press repeatedly until
the display shows the required set-
ting.
4. Press or repeatedly until the
display shows the right value.
You can change several settings.
5. To save the settings, press
for 3 seconds.