Siemens SN758X06TE - Setting Amount of Rinse Aid; Switching off Rinse Aid Refill Indicator

en Rinse aid
22
3. Close the lid.
Lid “clicks” into position.
4. Remove overflowed rinse aid with a
cloth.
This prevents excessive frothing
during the next rinse cycle.
Setting amount of rinse aid
The amount of rinse aid to be
dispensed can be set from 0 to 6. Set
the amount of rinse aid to be dispensed
to 5 to obtain a very good drying result.
Do not change the amount of rinse aid
unless there are streaks or water stains
on the utensils. Set a lower level to
avoid streaks. Set a higher level to
avoid water stains.
Set the amount of rinse aid as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press Info button { 8 for 3
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4. Keep pressing button > )R until the
rinse aid dispenser is indicated on
the display window at the top @.
5. Make the setting with setting buttons
+ - `.
6. Press and hold the Info button {
8 for 3 seconds.
The chosen setting has now been
stored.
Switching off rinse aid refill
indicator
If the use of combined detergents with a
rinse-aid component impairs the low
rinse-aid indicator H on the control
panel or the text on the front
display * ): (enough rinse aid for x
rinse cycles), the displays can be
switched off.
Proceed as described under “Setting
amount of rinse aid” and select
setting 0.
* depending on the features of your
dishwasher