Siemens SN85E800BE - Tableware Drying Problems

en Troubleshooting
52
Fault Cause troubleshooting
Plastic tableware is not dry. Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
▶
No remedial action possible.
Cutlery is not dry. Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Droplets can form on the cutlery con-
tact points.
1. "Arrange cutlery individually where
possible." →Page33
2. Avoid points of contact.
Appliance interior still wet
after wash cycle.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
No action required.
Remnants of food on table-
ware.
Tableware is placed too
close together or basket is
overfilled.
1. Arrange tableware with sufficient
space in between.
The spray jets must reach the sur-
faces of the tableware.
2. Avoid points of contact.
Spray arm rotation is
blocked.
▶
Arrange tableware so that it does
not obstruct spray arm rotation.
Spray arm nozzles are
blocked.
▶
Clean the "Spray arms" →Page46.
Filters are soiled.
▶
Clean the filters.
→"Cleaning filters", Page45
Filters are inserted incor-
rectly and/or not engaged.
1. Insert the filters properly.
→"Filter system", Page45
2. Engage the filters.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
→"Programmes", Page20
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page13
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page13