Siemens SN85E800BE - Detergent Residue and Water Marks

Troubleshooting en
53
Fault Cause troubleshooting
Remnants of food on table-
ware.
Tall narrow receptacles in
corner areas are not rinsed
adequately.
▶
Do not position tall narrow recept-
acles at too great an angle or in
corner areas.
Top baskets on right and left
are not set to same height.
▶
Set the top baskets on the left and
right to the same level.
→"Top basket", Page23
Detergent residue in the ap-
pliance
Lid of the detergent dis-
penser is blocked by items
of tableware parts and will
not open.
1. Arrange tableware in the top basket
tableware so the tab collecting tray
is not obstructed by tableware.
→"Arrange tableware", Page33
Items of tableware are blocking the
dispenser lid.
2. Do not place tableware or fra-
grance dispensers in the tablet col-
lecting tray.
The lid of the detergent dis-
penser is blocked by the tab
and will not open.
▶
Position the tab in the detergent dis-
penser crosswise, not vertically.
Tabs are used in the quick
or short programme. Dissolv-
ing time of the tab is not at-
tained.
▶
Select a more intensive "Pro-
gramme" →Page20 or use
"Powder detergent" →Page30.
Washing effect and dissolv-
ing performance are re-
duced after a prolonged
storage time or detergent is
very lumpy.
▶
Change your "detergent"
→Page30.
Water marks on plastic
parts.
Due to laws of physics
droplet formation on plastic
surfaces is unavoidable.
After drying water marks are
visible.
▶
Select a more intensive pro-
gramme.
→"Programmes", Page20
▶
Position tableware at an angle.
→"Arrange tableware", Page33
▶
Use rinse aid.
→"Rinse aid", Page29
▶
Set the water softening system
higher.
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page30.
▶
Clean the appliance mechanically.