Siemens SN85E800BE - White Coatings and Detergent Effectiveness

en Troubleshooting
54
Fault Cause troubleshooting
Wipeable or water-soluble
coatings are present inside
the appliance or on the door.
White coating is deposited in
the appliance interior.
1. Set the water softening system cor-
rectly.
In most cases you will need to in-
crease the setting.
2. Change your detergent if required.
Special salt dispenser is not
screwed tight.
▶
Screw the special salt dispenser
tight.
Stubborn white coatings are
present on tableware, inside
the appliance or the door.
Detergent substances are
deposited there. These coat-
ings cannot generally be re-
moved with chemicals.
▶
Change your "detergent"
→Page30.
▶
Clean the appliance mechanically.
The hardness range is set in-
correctly or the water hard-
ness is greater than 62°E
(8,9mmol/l).
▶
Set the Water softening system to
the water hardness or add special
salt.
3in1/organic/eco detergent
is not effective enough.
▶
Set the Water softening system to
the water hardness and use separ-
ate detergents (proprietary deter-
gent, special salt, rinse aid).
Too little detergent is being
used.
▶
Increase the amount of detergent
used or change "Detergent "
→Page30.
Washing programme selec-
ted too weak.
▶
Select a more intensive washing
programme.
→"Programmes", Page20
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page13
Tea residue or lipstick marks
on tableware.
Washing temperature is too
low.
▶
Select a programme with a higher
washing temperature.
→"Programmes", Page20
Too little detergent is being
used or is unsuitable.
▶
Use a suitable "Detergent "
→Page30 and follow the manufac-
turer's instructions for the amount
to be used.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
▶
Only remove large remnants of food
and do not prerinse tableware.
▶
Adjust the sensitivity of the sensors.
→"Sensors", Page13