Basic settings en
39
Basic setting Selection Description
Water connection Cold water
1
Hot water
Set cold water or hot water connec-
tion.
Only set the appliance to hot water if
this can be prepared with little energy
and a suitable installation is available,
e.g. solar heating system with circula-
tion line. The water temperature
should be at least 40°C and max.
60°C.
Eco forecast on
off
1
Switch EcoCheck on or off.
When selecting the programme, the
average water consumption and en-
ergy consumption is briefly shown on
the display.
emotionLight off
On via main
switch
1
On on opening
door
Switch the interior lighting of the appli-
ance on or off.
When the appliance door is opened,
the interior lighting switches off auto-
matically after 10 minutes.
timeLight on
1
off
Switch "timeLight" on or off.
While the programme is running,
status information is projected onto
the floor below the appliance door,
e.g. the remaining running time. If the
base panel is pulled forwards or if the
appliance is installed at eye level with
the cabinet front fitted flush, the dis-
play is not visible.
Start programme Eco 50°C
1
Last selected pro-
gramme
Set a default programme for when the
appliance is switched on.
Tone volume Scale with multiple
levels.
Set the signal volume at the end of
the programme.
Level 0 switches the signal tones off.
Button volume Scale with multiple
levels
Set the button volume during opera-
tion.
Level 0 switches the button tones off.
1
Factory setting (may vary according to model)
To Next Page
Loading...
