Fault, what to do? en
33
Food remnants on the
utensils.
Utensils placed too closely
together, utensils basket
overfilled.
Arrange utensils with adequate clearance
between them ensuring that the spray jets
can reach the surface of the utensils.
Prevent contact points.
Spray arm rotation obstructed. Arrange utensils so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles,
(see “Cleaning and maintenance”).
Filters 1j dirty. Clean filters (see “Cleaning and
maintenance”).
Filters 1j inserted incorrectly
and/or not engaged.
Insert and engage filters correctly.
Rinse programme too weak. Select a more intensive rinse programme.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils. Remove only large
food remnants.
Recommended programme Eco 50° or
Intensive.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Do not place hollow receptacles too
obliquely and do not place in the corner
area.
Top basket 1* on right and left
not set to same height.
Set top basket to same height using side
levers.
Detergent residue. Detergent dispenser cover
blocked by utensils and therefore
does not open fully.
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance dispenser
in the tablet collecting tray.
Detergent dispenser cover
blocked by the tablet.
Tablet must be inserted flat and not upright.
Tablets used in the quick or short
programme.
Dissolving time of the detergent
is not reached in the selected
short programme.
Dissolving time of tablets too long for a
quick or short programme.
Use a detergent powder or select a more
intensive programme.
Washing effect and dissolving
performance are reduced after a
prolonged storage time or
detergent is very lumpy.
Change detergent.
Fault Cause Remedial action
To Next Page
Loading...
Need help?
General
